D - Delete Address(Es); Set Scu Address; Example Application - ADTRAN MX2820 System Manual

D - Delete Address(es)

To delete a block of one or more contiguous address routes, follow these steps:
1. Enter the beginning route number and an ending route number.
2. Respond to the confirmation prompt if the specified routes are to be deleted.

Set SCU Address

This option (applicable only on a system whose Mode is Remote) designates the address route
for the IP address of the SCU. Options are as follows:
• Create a new route by pressing "0".
• Select from the existing routes by entering the route number.
The entry corresponding to the SCU is denoted with an asterisk (*) as shown in

Example Application

Refer to the example application illustrated in
The devices on the Remote side of the LAN consist of Device 1, Device 2, Device 3, an MX2800,
and the SCU of the Remote MX2820 system.
For each of these devices to be visible from both sides of the network, one of the provisioning
schemes that are possible is as follows:
• The Mode options of the MX2820 systems on the local and remote sides of the LAN must
be provisioned for Local and Remote, respectively.
• The IP forwarding addresses assigned for Mux #1 (for both MX2820 systems) consist of the
IP address of Device #1 (10.2.3.1).
• The IP forwarding addresses assigned for Mux #2 (for both MX2820 systems) consist of the
IP addresses of Device #2 (10.2.3.2) and Device #3 (10.2.3.3).
• The IP forwarding addresses assigned for Mux #3 (for both MX2820 systems) consist of the
IP address of the SCU of the Remote MX2820 system (10.2.3.4).
• The IP forwarding addresses assigned for Mux #4 (for the Local MX2820 system) consist of
the "Local IP address" of the MX2800 (10.2.3.5).
The provisioning menus utilized to establish IP Forwarding for the Local and Remote systems
in the example application are illustrated in
61186003L1-1D
Section 5, User Interface Guide - UIG-540, SCU Utilities
Figure 5-84 on page 5-116.
Figure 5-86 and Figure
Figure 5-85.
5-87.
5-119