Operation Settings; Confirming Connection Status - Omron WT30 Operation Manual

Registering the Communications Partner
3-5-3

Operation Settings

Serial Master Station Settings
1,2,3...
Note
3-5-4

Confirming Connection Status

I/O Slave Stations
1,2,3...
1. Before turning ON the power, set the function setting switch as shown be-
low to enable communications with the registered I/O Slave Stations.
Bit 2: ON (scan list enabled)
ON
1 2 3 4 5 6 7 8 9 0
When the scan list is disabled, however, communications are performed with
the number of I/O Slave Stations set using the node setting switch.
Example 1: If the node setting switch is set to 2, communications will be per-
formed with I/O Slave Stations 01 and 02.
Example 2: If the node setting switch is set to 64, communications will be per-
formed with I/O Slave Stations 01 to 64.
2. Change the setting for the mode setting switch to RUN mode, and then turn
ON the power.
RUN
TEST
SET
Confirm the communications status between the I/O Slave Stations and Serial
Master Station using the RSSI (received signal strength indicator) display. Be
sure to turn ON the power to the I/O Slave Station in RUN mode before the
Serial Master Station.
1. Confirm that the mode setting switch on the I/O Slave Station is set to RUN
mode.
RUN
TEST
SET
2. Confirm that the MS and WS indicators on the I/O Slave Station are lit
green.
MS: Module status indicator
WS: Wireless status indicator
MS WS
3. Check the strength of the received signal from the Serial Master Station in-
dicated using 10 levels on the RSSI display.
Many
Number of LEDs lit: Few
Strong
Field strength: Weak
Section 3-5
49