Omron WT30 Operation Manual page 66

Registering the Communications Partner
Note
48
2. Set the highest node number of the connected I/O Slave Stations using the
node setting switch.
W NODE
Setting range: 01 to 64
X10
X1
3. Set the frequency channel using the channel setting switch.
W CH
Setting range: 01 to 34, 51 to 83
X10 X1
4. Change the mode setting switch to SET mode, and then turn ON the pow-
er.
RUN
TEST
SET
The scan list registration will now start. During scan list registration the WS
indicator will flash green.
5. The WS indicator will change from flashing green to being lit green when
registration of the I/O Slave Stations (scan list registration) is completed.
WS WS
Confirm scan list registration using the RSSI. The RSSI's green indicators
will flash 4 or 5 times to indicate that registration has been completed.
Be sure to allocate node numbers to I/O Slave Stations in sequence. If the I/O
Slave Station numbers are allocated out of sequence, registration will not be
completed. Registration will also not be completed under the following condi-
tions.
• I/O Slave Stations are present for which the power is not turned ON.
• Communications are unstable and cannot be confirmed.
Flashing green Lit green
RSSI display: Green indicators flashing
Section 3-5