Installation - Omron WT30 Operation Manual

Installation

2-1-6 Installation
Table-top Mounting
Using an L-shaped
Bracket
Mounting Hole Dimensions (Unit: mm)
M4
120
Mounting Hole Dimensions (Unit: mm)
M4
120
22
The WT30 Terminal can be installed either by standing it on a table top, fixing
it with screws, or mounting it to a DIN Rail. When fixing with screws, mount
the WT30 Terminal to the L-shaped Surface Mounting Bracket before mount-
ing to a panel or other surface.
Attach the adhesive non-slip feet to the bottom of the Serial Master Station
and stand the Serial Master Station on a flat surface.
Adhesive non-slip feet
Holes are required for mounting with L-shaped Brackets.
Surface Mounting Bracket
Surface Mounting Bracket
Tighten the WT30 mounting screws using the specified torque of 0.5 to
0.6 N·m.
Mounting hole
W T 3 0
-M 0 1
-F L K
Serial Master Station
Mounting hole
W T 3
0 -
S ID 1
6
I/O Slave Station
Section 2-1
Surface Mounting Bracket
Surface Mounting Bracket