Function Setting Switch; Scan List Registration - Omron WT30 Operation Manual

Function Setting Switch

Serial Master Station
1,2,3...
3-6

Function Setting Switch

3-6-1

Scan List Registration

50
1. Confirm that the mode setting switch on the Serial Master Station is set to
RUN mode.
RUN
TEST
SET
2. Confirm that the MS and WS indicators on the Serial Master Station are lit
green.
MS: Module status indicator
WS: Wireless status indicator
MS WS
3. Specify the node number of the I/O Slave Station to be monitored on the
Serial Master Station's node setting switch.
W NODE
X10
X1
Note The Serial Master Station node number is set to the maximum
number of I/O Slave Stations. When the maximum number of
nodes is set to a number higher that the number of nodes connect-
ed, however, the highest node number is not used. The communi-
cations partner for this node number does not exist, so no display
is shown on the RSSI. If the node number is changed to that of a
node that is actually connected, the RSSI display will indicate the
corresponding signal strength.
4. Check the strength of the received signal from the I/O Slave Station spec-
ified by the node setting switch. The strength is indicated using 10 levels
on the RSSI display.
The details of the function setting switch are provided below.
Scan list registration is used to join and register I/O Slave Stations as commu-
nications partners in the network using the Serial Slave Station. This enables
communications to be performed with specified communications partners. Set
the operation mode to SET mode.
Bit 7: ON (register scan list enabled)
ON
1 2 3 4 5 6 7 8 9 0
Scan list registration is performed from the Serial Master Station using either
of the following two registration methods.
1. Registering all I/O Slave Stations automatically
2. Registering specified I/O Slave Stations
Setting range: 01 to 64
Few
Number of LEDs lit:
Field strength: Weak
Section 3-6
Many
Strong