Precautions For Correct Use - Omron WT30 Operation Manual

19. Always set the product after it is installed or replaced. Set the product cor-
rectly according to the manual, and be sure to perform the tests provided
with the product (e.g., communications tests) before operating it.
20. When operating the product without checking serial numbers, check
whether an existing system is present, and design the system carefully to
prevent radio interference.
21. Do not apply excess vibrations or shock to this product. Do not drop this
product.
22. Make sure that wiring and switch settings are correct before starting oper-
ations.
23. Other wireless devices operating within the same frequency band may in-
terfere with this product or be adversely affected by this product. Therefore,
be sure to perform the tests provided with the product (e.g., installation
tests) before operating it.
24. Make sure that the antenna is not disconnected during operation.
25. Do not use this product near other devices that may malfunction due to the
electromagnetic waves emitted by this product.
26. Turn OFF the power supply before performing any wiring or replacing de-
vices.
27. Do not touch the product with wet hands.
28. Dispose of the product as industrial waste.

Precautions for Correct Use

Always heed these precautions to prevent faulty operation, malfunction, or
adverse affect on the product's performance and functionality.
1. Communications performance will vary according to the operating environ-
ment. Always check operations before using the product.
2. Do not install the antenna in a location surrounded by metal, such as in a
control panel.
3. Install the antenna so that it is as far away as possible from and not parallel
to electric wires or metal plates.
4. Do not use this product in areas exposed to extremely high humidity, near
televisions or radios, near motors or drills that emit sparks, near strong
magnets, or near fluorescent lights.
5. Make sure that the terminal blocks, communications cables (RS-232C ca-
bles), and other items with locking devices are properly locked into place.
6. Do not pull or bend cables with force.
7. Do not change the mode selection switch during operation.
ix