Omron NS Programming Manual page 631

Section 5 Troubleshooting and Maintenance
NS Series Programming Manual
Errors Suggested cause as displayed
Command Specified password different from
error registered password (SRES:02).
(MRES:26)
Protected (SRES:03).
More than 5 commands process-
ing at command receive node
(SRES:04).
Service executing. (SRES:05)
Service not executed (SRES:06).
No authority to execute service
(SRES:07).
No response received due to
buffer error (SRES:07).
Settings not made before service
executed (SERS:08).
Required settings not made for
command data (SRES: 09).
Tried to register program using
already registered action/
transition numbers (SRES:0A).
Cause of error not removed
(SRES:0B).
Access Another node has the access
right error right. (SFC online edit using other
(MRES:30) node FIT is executed or ACCESS
RIGHT ACQUIRE or ACCESS
RIGHT FORCE ACQUIRE com-
mand executed on another node.)
(SRES:01)
Abort Interrupted by ABORT command
(SRES:01).
(MRES:40)
Possible countermeasure
Specify the correct registered password.
Use support software to remove the protection and
re-execute the command.
Close or stop a service being executed and
re-execute the command.
Close or stop a service being executed and
re-execute the command.
Execute the corresponding service as required.
Local node not in data link. Execute service from
node in data link.
Restart the Board. Replace the Board if the error
persists.
Make the required settings.
Check the command format and set the required
command data.
Change to unregistered action/transition numbers and
re-execute the command.
Remove the cause of the error and execute the
ERROR CLEAR command.
Wait until access rights are cleared and re-execute
the command. (Execute ACCESS RIGHT FORCE
ACQUIRE or ACCESS RIGHT RELEASE command
to enable execution of original command. Current
processing on the node that had access rights may be
affected, however.)
−−−−−−
5-26
5-2 Error Messages