Omron NS Programming Manual page 622

Section 5 Troubleshooting and Maintenance
NS Series Programming Manual
Message
Cannot cancel error by the
following case:
•
Operation mode is not in
program mode.
•
Cause of error at host side is
not yet removed.
Writing to this memory is not
possible.
Cannot write in during RUN
mode.
Force ON/OFF is not possible
with this address type.
Cannot connect to this PLC
model.
No project data.
Old password is NOT correct.
Password input in the confirma-
tion does NOT match with the
New Password.
Failed to save data to CSV file in
a Memory Card.
Check the Memory Card.
Changing value is set as
Disable so that the value cannot
be changed.
Changing value is set as
Disable so that the Mode cannot
be changed.
Failed to delete the file.
Printer error
Failed to stop the Memory Card.
It is not ready to be removed.
Cause
Not in program mode.
Cause of error not cleared on
host side.
Tried to write to AR.
Tried to write in RUN mode.
Tried to force ON/OFF DM or
EM.
Tried to connect a PLC that
cannot be connected to de-
vice monitor.
Tried to change settings even
though there is no project
data.
Input incorrect previous
password when changing
password.
Input the incorrect new pass-
word to the Confirmation input
field when changing pass-
word.
A Memory Card is not
inserted or the Card is not
one supported by the PT.
Device Monitor value modifi-
cation is disabled.
Device Monitor value modifi-
cation is disabled.
The file is a read-only file.
The printer cable is not con-
nected, the printer power is
OFF, or a printer error
occurred.
The Remove Button was
pressed while the Memory
Card was being accessed.
5-17
5-2 Error Messages
Possible countermeasure
Change to program mode.
Clear error on host side.
AR is write prohibited.
Select another memory area.
Change to program or monitor mode.
Select another memory area.
Check the PLC model and change to
permissible PLC type.
Download the project data.
Use CX-Designer to check the password
and input the correct password.
Enter the new password again.
Check to see if a Memory Card is inserted,
replace it if necessary, and try to save the
data again.
Use the PT Settings Tab Page under the
System Menu to enable changes to the
values.
Use the PT Settings Tab Page under the
System Menu to enable changes to the
values.
Clear the read-only setting.
Make sure the cable is properly connected
and the power is ON. Eliminate any printer
hardware errors, such as an empty paper
tray or empty ink cartridge.
Wait until the Memory Card stops being
accessed, and then press the Remove
Button again to remove the Memory Card.