Omron FQ User Manual page 131

Important
If the cycle time is too long, the PLC may not be able to detect when the BUSY signal is ON. If necessary, turn
OFF W0.00 after a suitable time elapses.
Registering the Measurement Reference Again
The model and reference color can be re-registered with commands from an external device, such as a PLC,
based on the image that was just input when the line process was changed.
Inspection item
Search
Color data
Edge Position, Edge Width, Area
Note
• Application is possibly only from the Run Mode
• If the parameter is applicable to more than one inspection item, it will be re-registered for all inspection items.
Settings
[In/Out] − [I/O setting] − [Input] − [Input mode]
Press [Expand mode].
Wiring
Color Signal State
Gray IN0 OFF
Green IN1 OFF
Red IN2 OFF
White IN3 ON
Purple IN4 OFF
Yellow IN5 ON
Orange OUT1 (BUSY) --
FQ User's Manual
Re-registered data
Model data
Reference color (hue, saturation, and brightness)
None
Description
Command parameter for registering the model
again
Command input for registering the model again
Processing in progress (default)
The signals shown at the left are
used.
Refer to the following information for
signal wiring.
2-4 Wiring: p. 28
Controlling the Sensor from an External Device
127