Omron DEVICENET SAFETY - 03-2008 Operation Manual page 60

Remote I/O Allocations
IMPORTANT Communications with up to 15 Safety Controllers for each connection can be
DST1-ID12SL-1
Network Configurator
setting
√ √
Safety input assembly 1
√ √
Safety input assembly 2
√ √
Safety input assembly 3
√ √
Safety input assembly 4
√ √
Safety input assembly 5
√ √
Safety input assembly 6
√ √
Standard output assembly
√
General status assembly
√
Test output status with gen-
eral status assembly
From among the I/O data, safety connections for up to four items, including
one output, can be allocated for the Master Unit and standard connections for
up to two items can be allocated for the Master Unit.
performed using multi-cast connection. If four connections are used, however,
only a maximum of 30 Safety Controllers total can communicate with the
DST1-series Safety I/O Terminals. Up to two safety connections can be used
with the DST1-XD0808SL-1.
The default values for the I/O assembly data are as follows:
Safety connections:
Default (Assembly instance number)
IN Safety input assembly 1 (Instance No. 20C)
OUT None
Standard Connections: The default values for each type of connection are
given below.
Connection
Poll IN Safety input assembly 6 (No. 312)
OUT Standard output assembly (No. 21)
Bit strobe IN Safety input assembly 6 (No. 312)
OUT None
COS IN Test out status with General status assembly (No. 340)
OUT None
Cyclic IN Test out status with General status assembly (No. 340)
OUT None
The following I/O data can be selected from the Network Configurator.
√
20C Input 2
√
224 Input 2
√
22C Input 3
√
310 Input 2
√
311 Input 4
√
312 Input 4
21 Output 1
300 Input 1
340 Input 2
Default (assembly instance number)
Inputs
√
√
√
√
√
Section 3-2
Outputs
√
√
√ √
√
√
√ √
39