Table of Contents
Advertisement
Use these commands to configure the system and management IP addresses and subnet masks.
18.1 IP Commands Summary
This table describes the commands.
Table 94 IP Commands Summary
COMMAND
show ip arp
no arp
show ip
show ip inband-mode
ip inband address <ip-address>/
<mask>
ip inband address dhcp
ip inband address dhcp
enable|release|renew
ip inband mgmt-vlan <mgmt-vid>
[pbit <pbit>]
ip inband default-gateway <ip-
address>
no ip inband
ip outband address <ip-address>/
<mask>
no ip outband
IES4005M User's Guide
C
HAPTER
DESCRIPTION
Displays the ARP table.
Flushes the ARP table entries.
Displays interface IP settings.
Displays the DHCP settings of the inband management (MGMT
port) interface.
Sets the inband management (MGMT port) interface's IP address
and subnet mask bit. Disables the DHCP client function if it is
enabled.
Sets the inband management (MGMT port) interface to be a DHCP
client.
Controls the DHCP client function on the inband management
(MGMT port) interface.
enable: turn the DHCP client function on.
release: release the dynamic IP address.
renew: renew the dynamic IP address
Sets the inband management VLAN and priority bit.
: 1-4093
mgmt-vid
pbit: 0-7, default 7
Sets the default gateway's IP address.
Sets the inband management IP address and subnet mask to the
default values. The default value is 192.168.1.1
Sets the management IP address and subnet mask for the out-of-
band management port.
ip-address: 0.0.0.1 ~ 223.255.255.255
: 0-32
mask
Sets the management IP address and subnet mask for the out-of-
band management port to the default values. The default value is
192.168.0.1
1 8
IP
M
P
E
1
E
13
E
1
E
1
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
141
Advertisement
Table of Contents
Troubleshooting
