Paradyne 3760 User Manual page 40

AT Command Set and S-Registers
Table 4-1. AT Command Reference (6 of 18)
AT
Command Description
X n Response Codes, Dial Tone Detect, Busy Tone Detect
This command controls three different configuration options.
Response Codes are the messages from the modem,
displayed as either words or numbers. This command controls
which response codes are reported from the modem.
Refer to Appendix C for more information on response codes.
Dial Tone Detect, if enabled, causes the modem to wait (up to
10 seconds) for a dial tone before dialing. If disabled, the
modem dials the call regardless of dial tone detection (also
known as blind dialing).
Busy Tone Detect, if enabled, sets the modem to monitor for a
busy tone. If disabled, the modem ignores busy tones.
X0
X1
X2
X3
X4
For all settings except X0, additional response codes may also
be enabled by changing the setting of the \V command.
Response codes are listed in Appendix C.
\V0 enables response codes 10–17.
\V1 enables response codes 10–17 and 22–30.
\V2 enables response codes 10–17 and 32–70.
Enables response codes 0–4.
Disables busy and dial tone detect.
Enables response codes 0–5 and 10–17.
Disables busy and dial tone detect.
Enables response codes 0–6 and 10–17.
Disables busy detect.
Enables dial tone detect.
Enables response codes 0–5, 7, and 10–17.
Enables busy detect.
Disables dial tone detect.
Enables response codes 0–7 and 10–17.
Enables busy and dial tone detect .
Issue 1 November 1994
4-7