Manually Answering A Call - Paradyne 3760 User Manual

Using Your Modem
If you would like to know more about disconnecting a call, refer
to the following commands in Chapter 4: +++ (escape
sequence), O (Return to Online Data Mode), X (Response
Codes, Dial Tone Detect, Busy Tone Detect), Y (Long Space
Disconnect), &D (DTR Control), \N (Set Operating Mode),
\T (Set Inactivity Timer), S7 (No Answer Time-out), and
S10 (No Carrier Disconnect).

Manually Answering a Call

The best way to answer a call is to set the Auto-Answer Ring
Number register (S0) to 1 or more rings. To enable this feature,
set the value of S0 to 1 or more rings. If S0 = 0 (which is the
default setting from the factory), you can use the ATA command
to manually answer incoming calls.
To use the A command to manually answer a call:
TYPE:
PRESS: Enter
NOTE:
DTR must be present (activated by the communications
software) for the modem to answer the call.
3-8
Issue 1 November 1994
ATA (after the modem rings)