Configuring A Destination For Snmp Traps - Paradyne 3166 User Manual

Configuring a Destination for SNMP Traps

"
3166-A2-GB20-20
A destination must be configured for each SNMP trap manager specified. This
configuration option is displayed for the number of trap managers specified by the
Number of Trap Managers configuration option.
Procedure
To configure an IP address for the SNMP trap manager:
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied into the Edit area by using the
appropriate Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the
the screen.
5. Select Mgmt.
Edit:
User Alarm Mgmt
F1
6. From the Mgmt Config screen, select Trap.
Mgmt Config:
Gen Trap
F1
7. Press F1 (Next) until the Trap n IP Address configuration option appears.
8. Press F2 (Edit) to edit the IP address. You have the option of using F3 (Clear)
to reset the IP address to the factory default 000.000.000.000 . Refer to
Setting the IP Address
address.
9. Press F1 (Next) until the Trap n Destination configuration appears, and select
the destination for the SNMP trap by using the appropriate Function key. Use
the scroll keys, if necessary.
Trap n Dst:
Next None
F1
March 1999
key until the Mgmt selection appears on
F2 F3
F2 F3
on page 3-21 for more information on setting an IP
Com
F3
F2
SDCP Operation
3-29