Table of Contents
Advertisement
SDCP Operation
Displaying LED Conditions
"
3-10
The same conditions monitored by the front panel LEDs can also be monitored
by the LED command. This command is most useful when the DSU/CSU is being
accessed remotely (see Appendix G,
Panel Emulation, no LEDs are shown on the PC's screen; you must use the Stat
command procedure described below to get LED information.
Procedure
To display LED conditions on the front panel screen:
1. From the top-level menu screen, select Stat.
2. From the Status screen, press the
the screen.
3. From the Status screen, select LED.
Status:
Perf
TStat
F1
4. From the Select LEDs screen, press the Function key that corresponds to the
interface for which you want to display LEDs.
Select LEDs:
T1
Prt1
F1
If you chose T1, the LED Display screen lists the LED signals, two at a time,
on the second line. A vertical bar at the left of the LED name indicates the
condition is ON, while an underscore indicates the condition is Off.
LED Display:
JNetSig
_Test
F1
March 1999
Front Panel Emulation
key until the LED selection appears on
LED
F3
F2
F2
F3
F3
F2
). When using Front
3166-A2-GB20-20
Advertisement
Table of Contents
