Table of Contents
Advertisement
1-2
Turning On the Terminal
Adjusting the Terminal
WY-99GT User's Guide
3 Connect the computer cable to the MODEM port and the
printer cable to the AUX port.
4 Plug the power cord into the terminal's power connector and
into a three-pronged grounded power outlet.
(If
you use an
adapter, be sure to ground the outlet.)
0
Note Make sure your building's voltage (120 in the U.S.)
matches the voltage shown on the back of the terminal.
Press the top half of the power switch to turn on the terminal.
You'll hear an immediate beep if the terminal has received
power.
0
Note
If
the bell sounds and an A, B, C, D, E, F, G, K, W, X,
Y, 6, or 7 appears at the bottom of the screen, press
I
Setup
I
(I
Select
I) to exit the self-test.
If
the error codes 0, 1, 9, p, or P
appear, call your service representative-the terminal needs to be
serviced by a qualified technician.
Adjust the screen's brightness with the dial in the right front
corner.
If
you want the keyboard slanted up slightly, turn it over
and unfold the hinged foot.
Advertisement
Table of Contents
