Table of Contents
Advertisement
Table 2-2
F1 DISP:
Display
Setup Parameters
WY-99GT User's Guide
D
Note
Explanations of setup parameters apply to the terminal's
native mode.
If
you select a parameter setting that's invalid for
the current personality, the terminal defaults to a valid setting
upon leaving setup mode.
Parameter
AUTOSCROLL
ON
OFF
ATTRIBUTE
CHAR
LINE
PAGE
BACKGROUND
DARK
LIGHT
CELL SIZE*
10
x
10
10
x
13
COLUMNS
80
132
CURSOR
BLINK BLOCK
STEADY BLOCK
BLINK LINE
STEADY LINE
DISPLAY CURSOR
ON
OFF
END OF LINE
WRAP
ON
OFF
LINES
24
25
48
50
Explanation
When the cursor moves past the last line of the page,
The data scrolls up one line
It
returns to the top of the same page
Display attributes are
Assigned to each character as
it
is entered
Active to the end of the line
Active to the end of the page
The screen displays
Light characters on a dark background
Dark characters on a light background
The character cell size is
Ten scan lines high
Thirteen scan lines high
The screen displays
80 columns
132 columns
The cursor display is a
Blinking rectangle
Steady rectangle
Blinking underline
Steady underline
The cursor is
Visible
Invisible
When additional characters are entered at the end of a
line,
The cursor wraps to the start of the next line
Characters at the cursor position are replaced
The screen displays
24 data lines, top status line, and label line
25 data lines and top status line
48 data lines, top status line, and label line
50 data lines and top status line
•
If
you change the cell size parameter and the FONT LOAD setup parameter is ON, the
screen will be blank for a few seconds when you leave setup while the font is loading.
2-3
Advertisement
Table of Contents
