Wyse WY-99GT User Manual page 12

2-4
Table 2-2 Continued
Table 2-3 F2 GENERAL:
General Setup Parameters
WY-99GT User's Guide
Parameter
SCROLL SPEED
JUMP
SMOOTH-8
SMOOTH-4
SMOOTH-2
SMOOTH-1
SCRN SAVER
ON
OFF
STATUS LINE
STANDARD
EDITING
OFF
Parameter
ANSWERBACK
CONCEAL
OFF
ON
1
ANSWERBACK
MODE
2
OFF
ON
COMM MODE
FULL DUPLEX
BLOCK
HALF DUPLEX
HALF BLOCK
ENHANCE
ON
OFF
Explanation
The display scrolls
At the rate data is received
Eight lines per second
Four lines per second
Two lines per second
One line per second
If the terminal receives no data for approximately 15
minutes,
The screen blanks until you press a key (no data is
lost)
Screen data displays continuously
The screen displays
A status line with time and cursor line and column
indicators
A status line with editing status messages
No status line
Explanation
The answerback message is
Displayed in setup mode
Concealed
The answerback message is
Not sent
Sent to the computer
The terminal's communication mode is
Full duplex
Block
Half duplex
Half-duplex block
In some nonnative terminal personalities, an
enhanced set of codes is
Recognized by the terminal
Not recognized by the terminal
1. If you conceal the message, you can't redisplay it-the message stays concealed until
you redefine it. The parameter defaults to off when you redefine the message.
2. In ANSI modes, the answerback message is always set in response to ENQ (CTRL-E) or
if CTRL BREAK is pressed. In ANSI mode this field determines if answerback message is
sent at power-on.