Table of Contents
Advertisement
B-32
Appendix B
Turning On the Terminal
Figure 2 Terminal Controls
Clearing an Error Condition
See "Setting Up the Terminal, "for
more information about steps 3, 4,
5, and 6.
WY-55/ES User's Guide
3
Slide the power switch on the front of the terminal (
s~e ~igure ~)
to the
right until it clicks into position. You'll see the power md1cator light
turn on and hear an immediate beep if the terminal is receiving power.
The terminal immediately runs a brief self-test during which patterns or
messages might be displayed on the screen.
Power------;;;:.;;)~rn8
Indicator
Light
Contrast _______ __.
Control
Brightness----------'
Control
Power
Switch
If the bell sounds and an error code appears at the bottom of the
screen,
1
Make a note of the error code letter or number.
2 Press
I
Setup
I (I
Shift
I
~,
I
Select
I)
to clear the error condition.
3 Enter setup mode (see "Setting Up the Terminal") and press
I
Enter
I
kpd to default the parameters to their factory settings.
4 Save the default settings and exit setup mode.
5 Enter setup mode and set up the terminal according to your system
requirements.
6 Save the settings and exit setup mode.
Advertisement
Table of Contents
