Alarm Clock - Wyse WY-99GT User Manual

Alarm Clock
Alarm Clock Display
Setting the Alarm
Turning Off the Alarm
WY-99GT User's Guide
In the alarm clock accessory you can set two alarm times and
enter two 20-character reminder messages. At the set time, the
alarm sounds for 30 seconds, and any reminder message is
simultaneously displayed on the status line.
D
Note The alarm sounds only during normal terminal operation,
not while the terminal is in WyseWorks or setup mode.
The alarm clock display shows
• The current time according to the terminal's clock (default
8:00 a.m.)
• Two alarm setting lines-Alarm 1 and Alarm 2-each with a
time field (default 12:00 a.m.), a 20-character message field,
and an on/off indicator field
Position the cursor in the appropriate fields:
1
Press the cursor keys or
~
or
I
Backspace
I
to go from field
to field. Pressing
I
Return
I (I
Enter
I)
moves the cursor to the
start of a line.
2 To reset the terminal's clock, enter the current time (12-hour
format, including a.m or p.m.) in the time field.
3
Enter the desired alarm time in the Alarm 1 or Alarm 2 time
field and the desired message in the message field.
4 In the on/off indicator field, press any key to toggle the alarm
bell to
on/off.
D
Note After the alarm sounds, the indicator defaults to
off,
but
the time setting and message remain until you redefine them or
turn off the terminal.
To turn off the alarm, press
I
Setup
I (I
Select
I).
Before you can resume normal operation or reenter WyseWorks,
you must press
I
Setup
I (I
Select
I )
again to clear the message
displayed on the status line.
4-5