Table of Contents
Advertisement
2-12
Table 2-78 F6 MISC2:
Misc Setup Parameters
(ANSI Personalities)*
WY-99GT User's Guide
Parameter
DISCONNECT
2 SEC
60 MSEC
LOCAL
OFF
ON
PORT
EIA DATA
EIA MODEM
RS-422
PRINT
ASCII
DRAW/ASCII
ALL
PRINT AREA
SCREEN
SCROLL RGN
PRINT MODE
NORMAL
AUTO
CTRL
PRINT TERM
NONE
FF
SEND
ALL
ERASABLE
Explanation
When the parameter PORT= EIA MODEM is selected
The terminal disconnects if the carrier is lost for two
seconds
The terminal disconnects if the carrier is lost for 60
milliseconds
All data received from the host
Is accepted; keyboard data can be processed locally,
sent to the host, or both depending on other
terminal modes
Is ignored, keyboard data is processed locally
The terminal transmits and receives via
RS-232-C data pins
RS-232-C modem signals
RS-422 signal levels
During printing
Escape sequences are not sent and non-ASCII
characters are replaced with underscores
Escape sequences and control codes are sent,
allowing ASCII and DEC line drawing graphics
characters, character attributes, and double size
lines to be printed
Escape sequences and control codes are sent,
allowing the printing of ASCII, line drawing,
multinational, double size lines, soft-font
characters, and character attributes
Print operations extend to the
Entire screen
Defined scrolling region
Data is sent to the printer
In response to PRINT keystrokes or PRINT escape
codes from the host
After processing a linefeed, formfeed, or vertical
tab; following an autowrap operation
From the host, without being displayed
Following print operations
No termination code is sent to the printer
The formfeed code (OCH) is sent to the printer
In block transmissions
Erasable and non-erasable data is sent to the host
Only erasable data is sent to the host
•
Parameters displayed when the terminal is in ANSI or TEK personalities. See Table 2-7 A
if you are in an ASCII personality.
Advertisement
Table of Contents
