Wyse WY-99GT User Manual page 46

A-12
Table B-9 Editing and Special
Key Codes1
WY-99GT User's Guide
VT220
VT220
Key
7-Blt 8-Blt VT100 VT52
VT220-Style Keyboard
BLOCK (F4) Local2 Same Same Same
BREAK (F5) LocaP Same Same Same
SHIFT BREAK (F5) Local
4
Same
Same Same
CTRLBREAK (FS) Local
5
Same Same Same
...
ESC [A CSI A ESC [A
ESC A
T
ESC [ B CSI B ESC [ B ESC B
....
ESC [ C CSI C ESC [ C ESC C
~
ESC [ D CSI D ESC [ D
ESC D
<E
DEL or
ass
Same Same Same
SHIFT
<E
CAN or DEL
8
Same Same Same
ENTER CTRL M
7
Same Same Same
FIND
ESC [ 1 - CSI 1 - None None
HOLD SCREEN (Fl) Local
8
Same Same
Same
INSERT HERE ESC[2-
9
CSI 2 - None None
NEXT SCRN
ESC [ 6 -
10
CSI 6 - None None
PREY SCRN
ESC [ 5 -
11
CSI 5 - None None
PRINT SCREEN (F2) Local1
2
Same Same Same
REMOVE ESC [ 3 -
13
CSI 3 -
None None
RESET (SHIFT F3) Local1
4
Same
Same Same
RETURN CTRL M
15
Same Same Same
1. Codes for cursor and numeric keypad keys apply only in numeric mode.
2. Toggles the terminal in .and out of block mode.
3. Sends break to DATA port. Length depends on BREAK parameter selection in setup
mode.
4. Sends two-second disconnect break to DATA port;
S. Sends the answerback message.
6. Action or code depends on DEL KEY parameter selection in setup mode.
7. Sends CTRL M, or CTRL M CTRL J, or CTRL I depending on ENTER field selection in
setup.
8. Toggles data communications on and off.
9. If block mode is on, toggles the terminal in and out of insert mode.
10. If block mode is on, clears from the cursor position to the end of the screen.
11. .If block mode is on, homes the cursor and clears the screen. Pressed with CTRL, the
cursor is homed and the screen cleared regardless of block mode.
12. Sends the contents of the screen to the PRINTER port. Pressed with CTRL or SHIFf,
toggles copy print mode on and off.
13.·
If
block mode is on, deletes the character at the cursor and moves the characters to
the right one position left.
14. Performs a terminal soft (modes) reset. Pressed with CTRL and SHIFf, performs a
hard (power-on) reset.
ts.
Sends CTRL M, or CTRL M CTRL J, or CTRL I depending on RETURN field selection in
setup.