IBM 3270 Manual page 133

Setting Up a New Screen of Your Own
To set up a new screen:
1. If your work station is not in Control Mode,
press the WSCtrl key.
The following line should appear at the
bottom of your screen:
WSCTRL WINDOW=A SCREEN=O
This line shows that window A on screen 0 is
active.
2. If your windows are enlarged, press the
Enlarge key to make them smaller.
3. Type a number from 1 through 9.
This will be the number of the new screen.
You can choose any number that is not
already being used for another screen.
4.
If you are not sure which screens are
available, press the PFI key.
A list of the screens that are in use will
appear at the right side of the screen. The
screens with no windows are not being used.
9-36
Book
3 -
Using the Control Program
I