Table of Contents
Advertisement
The condensed water created is collected in a tray (4) and conveyed via a pump to the tank (5) located
above the drum.
At this point, the air is now cold and dry and goes through the condenser (1) again, once again overheating
before entering the drum (3) and the gas now cooled in the evaporator (2) returns to the compressor where it
will once again be compressed and sent into the condenser (1) re-starting the cycle.
The entire gas evaporating and compressing system is kept in balance by a NTC (9) located at the entrance
to the capillary (8). This collaboration with the main circuit board ensures that if the outgoing temperature
from the condenser surpasses a certain level a fan (10) located in front of the compressor starts working and
lowers the temperature.
Technical Support - A.D.L.
9/69
599 76 86-51 Rev. 01
Advertisement
Table of Contents
