Table of Contents
Advertisement
7.17 Rear air seal
• Remove the back panel.
• Raise the air seal to remove it completely.
When repositioning the front air seal, make sure the
joint is approximately positioned as shown in the
figure.
7.18 Anti-entanglement cone
The anti-entanglement cone ensures that during the
drying stage the washing does not get tangled up in
itself.
• Press the blocking pin to remove and rotate the
cone anti-clockwise.
• Loosen the three fastening screws to also
remove the base.
• Insert the cone in its slot to re-assemble it and
rotate it clockwise until you hear a click that
indicates the correct insertion of the blocking pin.
Technical Support - A.D.L.
44/69
599 76 86-51 Rev. 01
Advertisement
Table of Contents
