Back Panel - Electrolux 599 76 86-51 Service Manual

7.16 Back panel

• Remove the worktop.
• Remove the sides.
• Use a pair of pliers to open the clamp and
disconnect the red pipe from the connector.
• Pull out the red pipe so it is free from the back
panel.
• Loosen the screws securing the tank fitting and
remove it.
• Disconnect the power supply cable from the main
board.
• Disconnect all the mass connections on the back
panel.
Warning to remove the connectors slightly lower the
locking lever indicated in the figure.
• Remove the rear air conduit.
• Loosen the 3 screws securing the back panel to
the appliance base.
• Loosen the 4 screws securing the rear panel to
the side crossbars and the screw securing it to
the central crossbar.
• Disconnect the steam pipe.
• Release the clip on the tank support.
• Tilt and remove the back panel.
Technical Support - A.D.L. 43/69 599 76 86-51 Rev. 01