Table of Contents
Advertisement
7.8 Control board
• Loosen the 9 fastening screws on the board.
• Using a screwdriver unhook the 10 fixing clips
and simultaneously lift up the whole board unit
until it has been completely removed.
7.9 Control board
• Using a screwdriver, release the fixing clips and
concurrently raise the entire board assembly until
it is fully removed.
• To remove the selector board and respective
dial, loosen the two screws that secure the board
to the control panel (do not loosen the central
screw).
• Move the clips that secure it in place and raise it.
In addition to the board, the selector dial will also be
removed: to remove the dial, simply slip it off the pin
Technical Support - A.D.L.
NEW COLLECTION
INSPIRATION RANGE
35/69
599 76 86-51 Rev. 01
Advertisement
Table of Contents
