Table of Contents
Advertisement
80
GETTING TO KNOW YOUR VEHICLE
Step Four
Step Four
5. Using the provided #40 Torx head driver and
ratchet, tighten the Torx screws by turning them
clockwise. Secure them until they are snug (refer to
the following table for recommended torque specifi-
cations), being careful not to cross-thread the
screws or overtighten. Repeat on the opposite side.
Step Five
1 — Lock Position
2 — Torx Head Screw
3 — Torx Head Screw
Torque Specifi-
cation For Torx
Maximum
Screws
119.5 in-lb
150.5 in-lb
13.5 N·m
17.0 N·m
CAUTION!
Do not overtighten the screws. You can strip the
screws if they are overtightened.
6. While pulling the release lever on the top of the rail
rearward, place the side link into the guide track on
the top of the rail then release the lever.
7. Unsnap and remove the black boot cover. This cover
should be discarded. It was intended as a protective
cover for shipping only.
Minimum
8. Raise the soft top
NOTE:
106.2 in-lb
Be sure the wire harness in the left rear corner is
12.0 N·m
not tangled in the soft top bows before you lift the
top.
Step Six
page 75.
Advertisement
Table of Contents
