Table of Contents
Advertisement
LED FRONT SIDE MARKER
See the following steps to replace:
1. Remove the front wheel liner fasteners to access
side maker screw and electrical connector.
2. Remove fastening screw in the back of the front side
maker assembly and disconnect electrical
connector.
3. Remove and replace LED front side marker light
assembly.
HALOGEN FRONT FOG LAMP
See the following steps to replace:
1. Reach under the vehicle to access the back of the
front fog lamp.
2. Disconnect the wire harness connector from the
front fog lamp connector receptacle.
3. Firmly grab the bulb by the two latch features and
squeeze them together to unlock the bulb from the
back of the front fog lamp housing.
4. Pull the bulb straight out from the keyed opening in
the housing and then connect the replacement
bulb.
CAUTION!
Do not touch the new bulb with your fingers. Oil con-
tamination will severely shorten bulb life. If the bulb
comes in contact with any oily surface, clean the bulb
with rubbing alcohol.
LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps they are
replaced as an assembly.
REAR TAIL, STOP, TURN SIGNAL, AND
BACKUP LAMP
See the following steps to replace:
1. Remove interior trim panel cap to access single
retaining screw for tail lamp assembly.
Trim Cap
2. Remove retaining screw and disconnect electrical
connector, then remove tail lamp assembly from the
vehicle.
NOTE:
If necessary, push in on the assembly tab located
inboard behind the lamp housing.
3. Remove the three screws from assembly bracket to
access bulb sockets.
4. Rotate the appropriate socket a quarter turn coun-
terclockwise, then remove it from the housing.
SERVICING AND MAINTENANCE
Bulb Removal
5. Pull the bulb straight from the socket to replace.
CENTER HIGH MOUNTED STOP LAMP
(CHMSL)
The stop lamp is mounted on a bracket that extends
upward from the swing gate behind the spare tire. If
service is needed, obtain the LED Assembly from an
authorized dealer.
See the following steps to replace:
1. Remove the spare tire.
2. Remove the screws holding the tire carrier cover.
3. Remove two screws from lamp assembly and dis-
connect electrical connector.
331
8
Advertisement
Table of Contents
