Table of Contents
Advertisement
5. Push and hold down the black security tab under
the wiring harness, and lift the harness lever into
the open position.
Open Wiring Harness
1 – Wiring Harness Lever (Open Position)
2 – Black Security Tab
6. With the wiring harness open, pull straight down-
ward on the wiring connector to unplug. Store the
wiring connector in the lower door basket.
7. With the door in the open position, remove the
check bolt from the door check attachment on the
bodyside (using a #T40 Torx head driver).
NOTE:
Keep the check arm in the extended position for
easier reinstallation. See note below if the check
arm gets pushed into the door while the door is off.
Door Check Arm
8. With the door open, lift the door with the help of
another person, to clear the hinge pins from their
hinges and remove the door.
To Install The Front Doors
1. Locate the upper and lower hinge pins on the door,
and lower them into the body hinges on the vehicle.
NOTE:
The upper hinge pin is longer, which can be used to
assist in guiding the door into place during
installation.
GETTING TO KNOW YOUR VEHICLE
Hinge Pin Locations
2. With the door in the open position, align the door
check bracket with the hole on the bodyside. Insert
the check screw and tighten using a #40 Torx head
driver to 19.9 ft· lb (27.0 N·m).
NOTE:
If the check arm is stuck inside the door, follow
these instructions to install the check arm.
a. Insert the check arm screw into the check arm
bracket. Ensure the screw is in the correct
orientation.
b. Slowly pull on the screw to draw the check arm
out until you encounter increased resistance. Do
not attempt to pull the check arm all the way out.
c. While sitting inside the vehicle, hold the door
partially closed and insert the screw into the hole
on the body.
d. Using your fingers, turn the screw clockwise at
least two full turns. Gently pull on the screw to
ensure it is secure.
27
2
Advertisement
Table of Contents
