Table of Contents
Advertisement
90
GETTING TO KNOW YOUR VEHICLE
WARNING!
•
Never leave children unattended in a vehicle, or
with access to an unlocked vehicle. Never leave
the key fob in or near the vehicle, or in a location
accessible to children. Do not leave the Keyless
Enter 'n Go™ Ignition in the ACC or ON/RUN posi-
tion. Occupants, particularly unattended children,
can become entrapped by the power top while
operating the power top switch. Such entrapment
may result in serious injury or death.
•
In a collision, there is a greater risk of being thrown
from a vehicle with an open power top. You could
also be seriously injured or killed. Always fasten
your seat belt properly and make sure all passen-
gers are also properly secured.
•
Do not allow small children to operate the power
top. Never allow your fingers, other body parts, or
any object, to project through the power top open-
ing. Injury may result.
Opening And Closing The Power Top
Express Open/Close
Push the open switch and release it within one-half sec-
ond and the power top will open automatically from any
position. The power top will open fully and stop
automatically.
Push the close switch and release it within one-half
second and the power top will close automatically from
any position. The power top will close fully and stop
automatically.
During Express Open or Express Close operation, any
other movement of the power top switch will stop the
power top.
Manual Open/Close
To open the power top manually, push and hold the
open switch to the full open position, then release.
To close the power top manually, push and hold the
close switch to the fully closed position, then release.
Any release of the switch during open or close opera-
tion will stop the power top movement. The top will
remain in a partially opened position until the switch is
operated and held again.
Pinch Protect Feature
This feature will detect an obstruction in the opening of
the power top during Express Close operation. If an
obstruction in the path of the power top is detected, the
power top will automatically retract. Remove the
obstruction if this occurs. Next, push the close switch
and release to Express Close.
WARNING!
There is no anti-pinch protection when the power top
is almost closed. To avoid personal injury be sure to
clear your arms, hands, fingers and all objects from
the top's path before closing.
NOTE:
•
The Power Sliding Top may reverse motion if closing
during a severe headwind. If this occurs, push and
hold the Power Sliding Top switch again to close the
top completely.
•
If three consecutive power top close attempts result
in Pinch Protect reversals, Pinch Protect will disable
and the power top must be closed in Manual Mode.
Power Top Maintenance
Use only a non-abrasive cleaner and a soft cloth to
clean the quarter window glass panel. For important
information on cleaning and caring for your vehicle
page 346.
Ignition Off Operation
The power top switch can remain active in Accessory
Delay for up to approximately 10 minutes after the vehi-
cle's ignition is placed to the OFF position. Opening
either front door will cancel this feature.
NOTE:
Ignition Off time is programmable through the Uconnect
system
page 177.
Relearn Procedure
For vehicles equipped with a power top, there is a
relearn procedure that allows you to calibrate the power
top when the "Express Mode" stops working. To reset
the power top, follow these steps:
1. Place the ignition in the RUN position, and start the
vehicle.
NOTE:
The engine must be running to perform the relearn
procedure.
2. Ensure the power top is in the fully closed position.
3. Push and hold the Close switch for 10 seconds. This
will put the power top into calibration mode.
4. Continue holding down the close button while the
top goes fully open and then back to fully close.
5. Once the power top has stopped in the fully closed
position, release the close button. The power top is
now reset and ready to use.
Advertisement
Table of Contents
