Table of Contents
Advertisement
Release Both Header Latches
3. From the front of the Sunrider® top, lift and push
the top rearward to the Sunrider® position.
Sunrider® Position
4. Secure the top by using the two hook-and-loop fas-
teners provided with the Sunrider® kit, and wrap
one around the side rails on each side of the
Sunrider® top to hold it in place.
Hook-And-Loop Fastener Placement
POWER SLIDING TOP —
IF EQUIPPED
CAUTION!
Lowering of the windshield is NOT recommended in
vehicles equipped with a Power Sliding Top. Damage
will occur to the top as well as the header seal.
If your vehicle is equipped with a Power Sliding Top, the
control switch can be found on the front trim panel, to
the right of the driver's side sun visor.
GETTING TO KNOW YOUR VEHICLE
Power Sliding Top Control Switch
1 — Open Switch
2 — Close Switch
NOTE:
•
The power top is non-removable. If desired, the rear
quarter windows can be removed and stored in the
provided storage bag
page 91.
•
The power top will not open in temperatures below
-4°F (-20°C). However, if it is opened at a higher
temperature, it can be closed at temperatures
above -40°F (-40°C).
•
The power top will not operate at vehicle speeds
above 60 mph (96 km/h).
NOTE:
A slight pause in audio may be heard when opening
and closing the Power Sliding Top as a result of the
Uconnect system switching between power top Closed
and power top Open audio modes.
89
2
Advertisement
Table of Contents
