Table of Contents
Advertisement
26
GETTING TO KNOW YOUR VEHICLE
Door Removal Warning Label
WARNING!
•
All occupants must wear seat belts during off-road
operation with doors removed. For off-road driving
tips, see
page 171.
•
Do not store detached doors inside of the vehicle,
as they may cause personal injury in the event of
an accident.
Outside rearview mirrors are mounted on the doors. If
you choose to remove the doors, see an authorized
dealer for a replacement cowl-mounted outside mirror.
Federal law requires outside mirrors on vehicles for
on-road use.
NOTE:
•
Doors are heavy; use caution when removing them.
•
Hinge pin can break if overtightened during door
reinstall (Max Torque: 7.5 ft· lb / 10 N·m). For off-
road driving tips, see
page 171.
•
When front doors are removed, the message "Blind
Spot Alert Temporarily Unavailable" will display in
the instrument cluster display. Power Mirrors and
Power Door Locks will also be unavailable.
To remove the front doors, proceed as follows:
1. Roll down the glass window to prevent any damage.
2. Remove the hinge pin screws from the upper and
lower outside hinges (using a #T50 Torx head
driver).
NOTE:
The hinge pin screws and nuts can be stowed in the
rear cargo tray located under the rear load floor.
Hinge Pin Screw
3. Remove the plastic wiring access door under the
instrument panel by sliding the plastic panel along
the door frame toward the seats until the tabs are
detached.
Wiring Access Door
NOTE:
Do not force open; this will break the plastic cover.
4. Pull up on the red locking tab to unlock the wiring
harness.
Closed Wiring Harness
1 – Red Locking Tab
2 – Wiring Harness Lever
Advertisement
Table of Contents
