Connections - Roland GP-100 Owner's Manual

Guitar preamp/processor
Hide thumbs Also See for GP-100:
Table of Contents

Advertisement

Using the number pedals to change banks: Use Num-
ber Pedal, Bank Pedal Only
FCz288 Bank Change
Bank Pedal Only
This specifies whether or not the number pedals will be used as
numeric keys to select Banks when the FC-200 is in Program
Change mode.
* This parameter corresponds to the FC-200's "Bank Change" setting.
Use Number Pedal:
When you press the Bank pedal UP, the second digit (10's
place) of the bank shown in the display will blink. Press the
desired number pedal to set the second digit of the bank
number. When you pressthe Bank pedal DOWN, the first digit
(1's place) ofthe bank shown in the display will blink. Press the
desired number pedal to set the first digit of the bank number.
* If you input a value that exceeds the Bank Limit, this operation will
be ignored.
Bank Pedal Only:
Each the you press a Bank pedal the bank will change, and will
be shown in the display. Pressing UP will move to the next
higher bank, and pressing DOWN will move to the next lower
bank.
Mode jack loop setting:
FC2BH
.
This setting determines how the mode will change when a foot
switch (FS-5U: BOSS) connected to the FC-200's Mode jack is
used to switch modes.
* This parameter corresponds to the FC-200's "Jack Loop."
FZSCCSFEL.
Program Change Mode
Control Change Mode
FCSCCAHTAFU
FCSCCSERSEPU
Control Change Mode
Exclusive Mode
FESCUCSHTSERSFU
Section 5 Appendix
ration Using the MCR-8
All panel operations of the GP-100 can be performed from the
MCR-8. This allows you to perform remote editing of the GP-100.
Connections
Connect the GP-100 and MCR-8.
The two devices must be set as follows.
GP-100:
MIDI Omni Mode:
Off
MIDI MCR-8 Edit:
Оп
MIDI MCR-8 CH:
16
MODE Switch:
4
COMPUTER Switch:
MIDI
MCR-8:
* Make sure that the GP-100's "MIDI MCR-8 CH" matches the MIDI
channel of the MCR-8. With the factory settings, both are set to MIDI
channel 16.
* When making connections, be sure to turn down the volume of your
amp system and turn offall power. Making connections with the power
on can cause malfunctions.
о.
20оооооо [С]
====ОоО
.
63

Advertisement

Table of Contents
loading

Table of Contents