Modifying The Patch Name Uu - Roland GP-100 Owner's Manual

Section 2 Modifying various settings
Example;Active Range Low:100, Active Range High:127
Amount of Change in
Controller — Parameter Value
100% 127
Median Value
100
Controller Parameter Value
Max. Value
Min. Value
0% ОЕЕ
* If you are using an on/off control source such as a foot switch, leave
this setting at "10:0", "Hi:127". Other settings may result in the value
not changing.
(Procedure)
1 Rotate the PARAMETER knob until the following parameter
appears in the display. By pressing the PARAMETER knob as
you rotate it, you can skip to the first parameter of each effect.
Target [Assign 1 Target
Master Level
Target value range [Assign 1 Target
MN Min ü
Target value range | Assign 1 Target
: Max | Мах 188
Source Mode| Assign 1 Source
Mode Harmal
Control value range | Assign 1 Source
"MIN Act. Range Lo 0
Control value range|nzsign 1 Source
: Мах fict. Range Hi 127
2 Use the VALUE knob to modify the setting.
3 Repeat steps 1—2 to make all desired control assign settings.
Modifying the Patch Name
Each Patch can have a name consisting of up to 16 characters. You
can freely assign names to each Patch you create to remind
yourself of the type of sound or the name of the song it is used for.
(Procedure)
12 3
prea GLOBAL TUNEN UTILITY
C COLL
ware шит матап еғаст
Caco coco
1 Rotate the PARAMETER knob until the following parameter
appears in the display. By pressing the PARAMETER knob as
you rotate it, you can skip to the first parameter of each effect.
Hame Edit
ample Setting
2 Usethe PARAMETER knob to move the cursor to the character
that you wish to modify.
З Use the VALUE knob to modify the character.
* If you press the PARAMETER knob, the character will change to a
space. Press it once again and the previous character will appear.
* By pressing the VALUE knob you can switch between upper and
lower case letters.
4 Repeat steps 1—3 to assign the Patch name.
23