Making The Connections - Roland KC-150 Owner's Manual

Making the Connections

Refer to the figure shown below to connect the KC-150 and the other equipment.
fig.03
Control Panel
Stereo
Headphone
INPUT
Mixer
Subwoofer
(With built-in amp)
Here is an example of a setup that makes full use of the KC-
150's mixer and monitor functions.
A microphone is input to CH 1, which accepts mic level
input. Connect a keyboard, recorder, or other sound-
generating device to the CH 2, CH 3 and CH 4 inputs.
* The signal that is input to CH 4 will not be output from the
line out jack.
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections. Set all of the KC-
150's channel volume knobs as well as the VOLUME knob to
zero.
* The pin assignment for the XLR type connectors is as shown
below. Before making any connections, make sure that this pin
assignment is compatible with that of all your other devices.
fig.04
8
Rear Panel
INPUT
CD Player
OUTPUT
Drum Machine
* Howling could be produced depending on the location of
microphone relative to speakers. This can be remedied by:
1. Changing the orientation of the microphone.
2. Relocating microphone at a greater distance from the speaker.
3. Lowering volume levels.
* When connection cables with resistors are used, the volume level
of equipment connected to the inputs (CH 1 through CH 4 and
AUX IN) may be low.
If this happens, use connection cables that do not contain
resistors, such as those from the Roland PCS series.
Microphone
OUTPUT
Keyboard