Ср-100 And Fc-200 Connections - Roland GP-100 Owner's Manual

Section 5 Appendix
GP-100 and FC-200 Connections
* Before making connections, be sure to turn off all power. Making
connections with the power turned on may cause problems,
o
-00
88000000 [==
* if you wish to use a foot switch to switch modes on the FC-200, connect
a BOSS FS-5U foot switch (optional) to the Mode jack of the FC-200.
* If you wish to use a BOSS FS-5U (optional) or BOSS FS-5L (optional)
as the foot switch, set the polarity switch as follows.
Selecting Patches from the FC-200
Here's how to select GP-100 Patches from the FC-200. Start the
procedure from the following state.
GP-100: the Play page
FC-200: Program Change mode
* if the GP-100 display shows something other than the Play page (p. 9),
press the [EXIT] button to return to the Play page.
Correspondence between GP-100 Patch numbers
and FC-200 Program numbers
GP-100 Patch numbers and FC-200 Program numbers have a
direct numerical correspondence. So, when you select a number
on the FC-200, the GP-100 will also switch to the identically-
numbered Patch.
* By using the MIDI Program Change Map (p. 56), you can also cause
differently-numbered Patches to be selected.
About FC-200 Program numbers
FC-200 Program numbers (1—400) are formed by adding the
program number corresponding to the Number (1—10) to the
program number for the Bank (0—39).
Banks 0—39 correspond to Program numbers as follows.
Bank 0 1 2.. 38 39
Program number 0 10 20... 380 390
Numbers 1—10 correspond to Program numbers as follows.
Number 1 2 3... 10
Program number 1 2 3.. 10
For example, if Bank=1 and Number=2, the Program Number
would be 10+2=12.
И Bank=2 and Number=10, the Program Number would be
20+10=30
59