Noise Suppressor; Eene Eet Etna Tnnt - Roland GP-100 Owner's Manual

Section 3 Effect Guide
Key
Specify the key of the song you are playing. By specifying the
key, you can create harmonies that fit the key of the song. The
key setting corresponds to the key of the song (#, |) as follows.
Major C F в Е А D cd
Pre Delay 'only for 4 Voice Harmonist
Adjusts the time from when the direct sound is heard until the pitch
shifted sounds are heard. Normally you can leave this set at "Oms."
Pan 'only for 4 Voice Harmonist |
Adjusts the stereo position (pan) for each pitch shifted sound.
Effect Level, Level
Adjusts the volume of the Harmonist effect.
Harmonist 1 Feedback 'only for 4 Voice Harmonist
Adjusts the volume at which the pitch shifted sound is fed back.
* Only Harmonist 1 will be fed back, and mixed with the input signal.
Direct Pan
Adjusts the stereo position (pan) of the direct sound.
Direct Level
Adjusts the volume of the direct sound.
Master
Level
Adjusts the output volume of the GP-100.
Mixer
Adjusts the volume for each channel of the DUAL algorithm.
Channel 1 Level
Adjusts the volume of channel 1.
Channel 2 Level
Adjusts the volume of channel 2.
Noise Suppressor
This effect reduces the noise and hum picked up by guitar pickups.
Since it suppresses the noise in synchronization with the envelope
of the guitar sound (the way in which the guitar sound decays over
time), it has very little effect on the guitar sound, and does not harm
the natural character of the sound.
Threshold
Adjust this parameter as appropriate for the volume of the noise.
Ifthe noise level is high, a higher setting is appropriate. Ifthe noise
level is low, a lower setting is appropriate. Adjust this value until
the decay of the guitar sound is as natural as possible.
* High settings for the Threshold parameter may result in there being no
sound when you play with your guitar volume turned down.
Release
Adjusts the time from when the noise suppressor begins to function
until the volume reaches "0".
Envelope Input
Specify the point where the noise suppressor detects the envelope.
Guitar: The envelope of the input level at the INPUT Jack will be
used.
NS: Theenvelopeofthe input level to the noise suppressor will
be used.
* Normally you will set this at "Guitar."
* If reverberation-type effects such as delay or reverb are connected
before the noise suppressor, set this to "NS" to prevent the reverbera-
tion from being cut off unnaturally.
45