Selecting Patches From The Fc-200; Control Assign Operations Using The Ес-200 - Roland GP-100 Owner's Manual

Section 5 Appendix
FC-200 operations
Here's how to use the Bank and Number pedals of the FC-200 to
select GP-100 Patches.
1. Selecting the bank.
Each time you press a Bank pedal (UP/DOWN) the bank will
change, and will be shown in the display. Pressing "UP" takes you
to the next higher bank, and pressing "DOWN" takes you to the
next lower bank.
* Simply changing the Bank number will not make Program numbers
change. The Program number will change when you next select a
number.
2. Selecting the number.
Press a Number pedal (1—10). The number pedal indicator will
light, and the Program number will change. At the same time, the
GP-100 Patch number will change.
* If you wish to select a program number which has the same Bank
number as the previous selection, it is not necessary to re-select the
Bank,
* in addition to this procedure, it is also possible to change program
numbers just by selecting a different Bank, or to use the number pedals
as numeric keys when selecting a Bank. For details refer to "Changing
FC-200 Settings from the GP-100" (p. 62).
60
Control Assign Operations Using the
FC-200
Using the control pedal
When the FC-200's CTL pedal is pressed, Control Change mes-
sages (controller number 80) will be transmitted from the FC-200.
The GP-100 can receive these Control Change messages as one of
the "control assign sources" specified in each Patch, and control
the specified target parameters.
* The CTL pedal can be used when the FC-200 is in "Program change
mode" or "Control change mode."
* The control pedal is a "momentary-type" pedal which transmits on
(max) when pressed and off (minimum) when released. It is possible to
change it to a "latch-type" pedal that transmits on or off each time the
pedal is pressed. For details refer to "Changing FC-200 Settings from
the GP-100" (p. 62) or the FC-200 owner's manual.
For example by making the following control assign settings for a
control source "Assign2"—"Assign 16," you can use the control
pedal to switch the TUNER on/off.
For details on control assign, refer to "Control Assign Settings" (p.
21).
Target TUNER On/Off
(Target Min Off)
(Target Max On)
Source MIDI CTL #80
Source Mode Toggle
(Source Act.Range Lo 0)
(Source Act.Range Hi 127)
Using the expression pedal
When the FC-200's expression pedal is moved, Control Change
messages (controller number 7) will be transmitted from the FC-
200.
The GP-100 can receive these Control Change messages as one of
the "control assign sources" specified in each Patch, and control
the specified target parameters.
* The control pedal can be used when the FC-200 is in "Program Change
mode," "Control Change mode," or "Note mode."
For example by making the following control assign settings for a
control source, "Assign! "—"Assign 8," you can use the expression
pedal to control the Master Level.
For details on control assign, refer to "Control Assign Settings" (р.
21).
Target Master Level
Target Min Off
Target Max On
Source MIDI CTL #7
Source Mode Normal
(Source Act.Range Lo 0)
(Source Act.Range Hi 127)