Ы Ыдын Ркы Ныкы Өгөй; Restoring The Factory Settings (Initialization); Tuner - Roland GP-100 Owner's Manual

Section5 Appendix
Factory Settinc
«Global»
Low EQ: 0 dB
High EQ: 0 dB
Threshold Level: 0 dB
Reverb Level: 100%
OUTPUT Channel: Patch
SP Simulator: Patch
Amp Being Used:A: Solid State
SP Being Used:A: Built In
SP Color:A: Straight
Amp Being Used:B: Solid State
SP Being Used:B: Built In
SP Color:B: Straight
PREAMP/PROCESSOR: Coupled
<Tuner>
TUNER Pitch: A = 440 Hz
TUNER Level: 0%
<Utility: Function Settings>
OUTPUT A Level: +4 dBm
OUTPUT B Level: +4 dBm
SEND 1 Level: -10 dBm
RETURN 1 Level: -10 dBm
SEND 2 Level: -10 dBm
RETURN 2 Level: -10 dBm
EFFECT/EXP PEDAL: EFFECT REMOTE
CONTROL 1 Jack: Number Up
CONTROL 2 Jack: Number Down
Number Up/Down: Min: 1
Max: 400
EFFECT Off: Direct
Assign Hold: Off
LCD Contrast: 15
«Utility: MIDI-Related Settings»
MIDI Channel: 1
MIDI Omni Mode: Omni On
MIDI OUT/THRU: MIDI OUT
MID! MCR-8 Edit: Off
MIDI MCR-8 CH: 16
MIDI Map Select: Fix
MIDI Program Map: same as Fix
«Utility: Harmonist Settings»
same as Preset Scale
«Utility: FC-200 Settings»
FC200 CTL Pedal: Momentary
FC200 Bank Limit: 39
FC200 PC Out: Number
FC200 Bank Change: Bank Pedal Only
FC200 Jack Loop: PC-CC-PC
72
Restoring the Factory Settings (Initialization)
If you wish to restore the GP-100 to the factory settings, use the
following procedure (Initialization). You can choose to initialize
all settings, or initialize only a specified area of data, such as Patch
data in the user area or system settings such as Utility data.
The following types of data can be initialized.
PREAMP Settings[1]—[4]
Settings for Patch Number 1
Settings for Patch Number 2
Н Н
H Н n
н H Н
| #199 | Settings for Patch Number 199
| #00 | Settings for Patch Number 200
* System data includes the preamp settings 1—4.
(Procedure)
2,4 3,5 1,2
PARAMETER beg eh POWER
a
Turn off the power.
N
While pressing the PARAMETER knob, turn on the power. A
display will appear, allowing you to specify the area of data
you wish to initialize.
* If you decide not to initialize the settings, press the [EXIT] button.
Initialization will be canceled, and the normal power-on display
will appear.
Starting Point Ending Point
о
Use the VALUE knob to specify the beginning of the area to be
initialized.
>
Use the PARAMETER knob to move the cursor to the setting for
the end of the area to be initialized.
о
Use the VALUE knob to specify the end of the area.
6 Press the [WRITE] button, and the specified area of data will
be initialized. The GP-100 will then be in its normal power-on
state.