Connections; Switching The Power On And Off - Roland CUBE STREET Owner's Manual

Connections

Refer to the figure shown below to connect the CUBE STREET to other equipment.
fig.01-02
CD/MP3
player Headphone
Mic
Acoustic Guitar
Keyboard

Switching the Power On and Off

Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1. Make sure that all volume controls on the
CUBE STREET and connected devices are set to 0.
2. Turn on all the devices connected to the CUBE STREET 's
input jacks (INPUT jack and AUX IN jack).
3. Turn on the CUBE STREET.
4. Adjust the volume levels for the devices.
5. Before switching off the power, lower the volume on each of
the devices in your system and then TURN OFF the devices
in the reverse order to which they were switched on.
* This instrument is equipped with balanced XLR/TRS type
jacks for microphoes. Wiring diagrams for these jacks are
shown below. Make connections after first checking the wiring
diagrams of other equipment you intend to connect.
fig.XLR/TRSJack.eps
* If there are batteries in the unit while an AC adaptor is being
used, normal operation will continue should the line voltage be
interrupted (power blackout or power cord disconnection).
10
If using a FS-6 switch, set the MODE and
POLARITY switches as shown below.
B A
Electric
Guitar
Mic
Acoustic Guitar
Keyboard
Footswitches
FS-6 FS-5U
DLY/REV EFX DLY/REV
red
Stereo 1/4"
phone plugs
at both ends
PCS-31
Stereo 1/4" phone
plugs at both ends
DLY/REV MUTE
FS-6
* When operating on battery power only, the unit's indicator
will become dim when battery power gets too low. Replace the
battery as soon as possible.
* Howling could be produced depending on the location of
microphones relative to speakers. This can be remedied by:
1. Changing the orientation of the microphone(s).
2. Relocating microphone(s) at a greater distance from
speakers.
3. Lowering volume levels.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally. For protection from sudden big sound,
always make sure to have the volume level turned down before
switching on power. Even with the volume all the way down,
you may still hear some sound when the power is switched on
and off, but this is normal, and does not indicate a malfunction.
* If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power
outlet. Refer to "Power Supply: Use of Batteries" (p. 4).
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
* Before making the connections, be sure that the volume setting
of the VOLUME knob for both amplifiers is set to "0."
* When connection cables with resistors are used, the volume
level of equipment connected to the inputs may be low. If this
happens, use connection cables that do not contain resistors,
such as those from the Roland PCS series.
Polarity
FS-5U FS-5U
Switch
EFX EFX
white
PCS-31
red
white
DLY/REV MUTE MUTE
FS-5U FS-5U FS-5U
Footswitches