Receiving Data (Bulk Load) - Roland GP-100 Owner's Manual

<Transmission Procedure>
1 2 3
OO
EE EE E
CoCo Co
5 6
1 Each time you press the [UTILITY] button, the following items
will appear in succession. Call up the MIDI-related items on
the display.
* When you have gone through all items the first one will reappear.
* While utility function settings are being made, the button indicator
will be lit.
«Function Settings»
«MIDI-Related Settings»
MIDI Channel
Channel = 1
Make settings for operations using MIDI.
«Harmonist Settings»
«FC-200 Settings»
2 Rotate the PARAMETER knob until the following parameter
appears in the display.
MIDI Bulk Симе
Теме System +
3 Use the VALUE knob to modify the start and end points.
4 Repeat steps 2—3 to set the start and end points of the data to
be transmitted.
5 Press the [WRITE] button to transmit the data.
MIDI Bulk Dumr
Data Dumring...
When the transmission has been completed, the previous
display will reappear.
6 Press the [EXIT] button to end the procedure.
Section 4 Using MIDI
Receiving Data (Bulk Load)
«Connections»
When receiving data saved on a sequencer into the
GP-100
Make connections as follows. Set the GP-100 to the MIDI channel
(=Device ID) to which it was set when transmitting the data.
ооосоо o Oo
ogge oo coo
oo оос
ooo сло 3200
с с oon
MIDI OUT
MIDI IN
e O
: o0
© :88eoeooe[L— zzz200D °
* For details on sequencer operation, refer to the manual for the device
you are using.
«Reception Procedure»
1 Pressthe [UTILITY] button several times until the MIDI-related
items appear in the display. Each time you press the [UTILITY]
button, the following items will appear in succession.
* When you have gone through all items the first one will reappear.
* Whileutility function settings are being made, the button indicator
will be lit.
«Function Settings»
«MIDI-Related Settings»
MIDI Channel
Channel = 1
Make settings for operations using MIDI.
<Harmonist Settings>
<FC-200 Settings>
35