Output Channel Settings Wo; External Control Settings; Control Assign Settings; Target Value Range - Roland GP-100 Owner's Manual

Section 2 Modifying various settings
OUTPUT Channel Settings
The GP-100 has two sets of stereo output jacks. For each Patch,
you can specify the output channel(s) that will be used. For
example, you might use this capability to switch between lead and
rhythm output channels.
* By using the Global function (p. 25) you can also specify the output
channel that will be used regardless of the settings of each Patch.
(Procedure)
1 Use the PARAMETER knob to select the following parameter.
2 Use the VALUE knob to set the output channel.
OUTPUT A: Output from OUTPUT Jack A.
OUTPUT B: Output from OUTPUT Jack B.
OUTPUT A&B: Output from both OUTPUT Jacks A and B.
External Control Settings
By connecting the GP-100's EXT CTL 1/2 jack to the remote jack
of an external device, you can have external devices be switched
on/off depending on the GP-100 Patch that is selected.
* The external device's "remote jack" is the jack to which a foot switch
would normally be connected. Since various devices may behave
differently, you should try this feature out first to make sure the on/off
operation works the way you want with your unit.
(Procedure)
1 Usethe PARAMETER knob to access the following parameter.
EXT CTL 1
EAT CTL 2
2 Use the VALUE knob to make the On/Off setting.
On: Theexternal device will be turned on.
Off: The external device will be turned off.
Control Assign Settings
These settings allow you to contro! GP-100 parameters as you
play, either from external MIDI devices or from pedals connected
to the GP-100. For each Patch number, you can specify up to 16
parameters (assign numbers 1-16) and the controller that will
control each parameter.
Target: the parameter that will be controlled
Specify the parameter you wish to control. The following param-
eters can be selected as targets.
* Up to 16 Control Assign settings can be made for each Patch, but
unused control assign targets must be set to "Not Assign."
* You may assign two or more controllers to control the same target, but
in this case, avoid using two of these controllers to simultaneously
modify the target parameter. This can produce noise.
Effect unit parameters (*)
Effect On/Off for each effect
Master Level
OUTPUT select
External control 1/2
EFFECT On/Off
TUNER On/Off
* There are limitations on the effect parameters that can be selected as
targets. Refer to "Section 3 Effect Guide" (p. 30).
* The parameters that can be selected as targets differ according to the
assign numbers (1, 2—8, 9—16).
Target value range
Operations on the external device will modify the value of the
target parameter within the range of the "minimum" and "maxi-
mum" values you specify.
For on/off-type controllers such as foot switches, "Off" (CLOSE)
will producethe "minimum value" and "On" (OPEN) will produce
the "maximum value." For continuous controllers such as expres-
sion pedals or pitch bend levers, the value will change within the
range of the specified "minimum" and "maximum." If the target
parameter is an on/off-type parameter, it will be switched on/off by
controller values above or below the center value.
Assign 1 Tarde
t
A
21