Door Lock Replacement Instructions - Traulsen G Series Service Manual

3.4.2 Door lock replacement instructions

Figure 19 Unlock position
3.4.2.1 Disassembly of lock:
To remove the lock cylinder for replacement, insert the Core Removal Key into the lock, causing the Spline to
lower so the lock cylinder can be removed. Move the key up and down, then pull backwards; the core key will
pull the lock cylinder along with it. The Lock Bolt is now free to slide out of the Lock Barrel for replacement (if
applicable).
3.4.2.2 Assembly of lock:
Insert the Lock Bolt into the Lock Barrel until the groove in the bolt is approximately in the locked position.
Insert the Core Removal Key into the Lock Cylinder (causing the Spline to lower) and insert the Lock Cylinder
into the Lock Barrel (NOTE: Lock Stud must be lined up with Lock Bolt groove). Use one hand to firmly hold
the Lock Cylinder in place, then remove the Core Key with the other (causing Spline to rise and securing Lock
Cylinder).
NOTE: Lock Barrel is assembled to the door during production at the factory. A damaged Lock Barrel requires
door replacement.
Core Removal Key should only be used for lock replacement. Use of Core Removal Key to lock and unlock the
door will cause the Lock Cylinder to fall out.
LOCK STUD
SPLINE
Figure 20 Lock Position
25