Doors & Hardware; Hinges; Removing The Doors And Hardware - Traulsen G Series Service Manual

3. Doors & Hardware
3.1

Hinges

3.1.1 Removing the Doors and Hardware:

To fit through narrow (less than 35") doorways, it may be necessary to remove the door(s), and/or
hinges. To remove any solid door, begin by removing the safety screw at the bottom of the top hinge
which secures the door in place. Remove this with a #2 Phillips screwdriver and the door can then be
lifted off the hinges. After removing the door, it may be necessary to remove the hinge assembly and
hardware from the door itself. If it is necessary to remove the hinge hardware from the cabinet, begin
by removing the three Phillips head screws which hold it in place. Set these components aside for later
reassembly. Pay special attention not to lose the door switch actuator button.
The lock keeper may also require removal to reduce the overall cabinet depth to 32".
First remove the lock keeper strike plate by removing the two Phillips head screws which secure it in place exposing
the adjustment screws. Then remove both adjustment screws from the mounting plate to remove. See figure
11. To re-install the door and/or hinges, please reverse the appropriate sections of the preceding procedure.
Figure 11 Hinge assembly
18