Traulsen G Series Service Manual page 18

Reach-in & pass thru refrigerator & freezer

Hide thumbs Also See for G Series:

Table of Contents

To clean the condenser, first disconnect electrical power to the cabinet and lift the

front louver assembly. To lift this, remove the two screws located on both sides at the

bottom of the louver assembly (see Figure 5). Once the screws are removed, the panel

can be pivoted upwards allowing full access to the front facing condenser

Use a soft bristle brush to remove any dirt, lint or dust from the finned condenser coil,

around the compressor and other cooling system parts as indicated. Be sure to brush

in the direction of the fins to prevent damage. If significant dirt is clogging the

Cleaning

condenser fins, use compressed air to blow this clear. When finished reverse the

louver removal process as instructed above. Compressor warranty claims will not

be paid for units with dirty condensers.

Table 8 Condenser Coil Cleaning PM Procedure

Table of Contents

Troubleshooting