Canon NP-1010 Service Manual page 48

2 No Second Paper (pick-up delay jam)
If the second or following copy paper fails to reach the pick-up unit paper sensor within the
specified time (no paper in the cassette), an ADD PAPER condition is identified, and the main motor
stops 0.5 seconds after the delivery unit paper sensor goes OFF and the message ADD PAPER is in-
dicated. If the pick-up unit paper sensor detects copy paper after an ADD PAPER condition is identi-
/-.
fied and before the main motor stops, a pick-up delay jam is identified and the message JAM is indi-
cated (flashing).
This ADD PAPER/JAM detection is not performed in the manual mode.
(ADD PAPER)
IJAMI
Figure 3-41
3 Pick-Up Stationary Jam
If the copy paper fails to pass the pick-up unit paper sensor within the specified time (faulty
feed), an pick-up stationary jam is identified, the copier is stopped at once, and the message JAM is
indicated (flashing).
COPY START key
ON
0%
V
ISTBYl INTR 1 SCFW lSCRV[ SCFW 1
i
Figure 3-42
3-30 COPYRIGHT 01980 CANON INC.
CANON NP-IO10 RN.0 DEC. IQ08 PAINTED IN JAPAN (IMPAIME AU JAPONI