Table of Contents
Advertisement
/'-
/'--
,/--
tep
Procedure
Checks
Remarks
I1
Connect the power plug to the
.
Check that the MAIN/WAIT
copier and the outlet, and shift
indicator flashes.
the power switch to '(1.
.
Check the movement of the
COPY DENSITY lever.
Press the f,
-,
CLEAR/COPY
STOP keys to check that the
copy count is correct.
.
Press the AE key. to check
that the AE indicator goes OFF,
or ON.
.
Press the REDUCTION/
ENLARGEMENT key to check
that the reproduction
mode
'changes.
+
Press the ZOOM key to check
that the ZOOM indicator goes
ON; press the + and -
keys
to check that the zoom ratio
displayed is correct.
I2
Open the delivery cover, and
The copier supplies toner into
hold the ZOOM and CLEAR/
the cylinder for about 3 min.
STOP keys down, and close the
delivery cover.
13
Press the COPY START key
Check that the copy count is 'P'
when the MAIN/WAIT
indicator
when the COPY START key is
goes ON.
pressed without copy paper.
I4
Place copy paper in the
cassette, and set the cassette in
the copier.
I5
Set the Test Sheet on the
*
Check that the copier is free of
copyboard, and check the
abnormal noise.
copying operation.
.
Check that copies are made in
the number specified.
I6
Clean the outside of the copier
and its vicinity, and record
necessary information
on the
Service Sheet.
Figure 5-2
COPYRIGHT
Ol9GG ClNGN INC.
CANON
HP-1010 RN.0 DEC. 1988 PRINTED
IN JIIMN [IMPAIME 1U JAPONI
5-3
Advertisement
Table of Contents
