Table of Contents
Advertisement
Basic Copy Operation
Shift the power switch to 'I'.
If the temperature
of the fixing assembly is
below the specified value, the MAIN/WAIT
indicator flashes at long intervals.
If the COPY START
key is pressed at the
time, the indicator starts to flash at short
intervals to indicate that copying will start
as soon as the temperature
reaches
the
specified value.
If the COPY START key is not pressed, the
indicator
remains lit as soon as the tem-
perature
reaches the specified
value to in-
dicate that the copier is ready.
The copier normally needs about 30 set to
warm up (at 20°C).
Open the copyboard
cover, and place the
document
face down aligned with the size
index.
See Figure l-5.
Sire
index
Figure l-5
Press the A key if manual adjustment
of
the density
is desired;
use the exposure
control
lever to
suit the density
of the
document.
Press the REDUCTION/ENLARGEMENT
key
or ZOOM MODE key as desired.
When
the
ZOOM
MODE
key is pressed,
the ratio may be in 1% increment
between
70% and 122%.
When
the
REDUCTION/ENLARGEMENT
key is pressed, each press activates the re-
production
ratios as shown in Figure 1-6.
Figure l-6
Check that the cassette
is set in the cas-
sette holder.
Press the
COPY
NUMBER
INPUT
key to
set
the
number
of
copies
to
make
(I
through 99), and check the number on the
COPY NUMBER indicator.
Press the COPY START key.
Copying
will not
start
while
the
MAIN/
WAIT
indicator
is flashing;
however,
the
COPY START
key may be pressed
at the
time so that copying will start as soon as
the, copier is ready.
To
stop
continuous
copying,
press
the
CLEAR/STOP
key. The
copier stops after
completing
the current copy. The number
on the indicator will be the one set initially.
Manual
Feeding
Set a document
on the copyboard.
Press the A key to clear the AE mode if
manual
adjustment
of the density
is de-
sired; thereafter,
use the EXPOSURE
CON-
TROL lever to suit the density of the docu-
ment.
Slide the guide on the manual tray to suit
the size of the copy paper.
Feed the copy
paper
along the guide of
the manual tray.
The copier starts automatically
as soon as
it detects the copy paper.
The copy paper may be placed on the tray
even
while
the
MAIN/WAIT
indicator
is
flashing;
the paper
will be fed
into the
copier,
and copying will start as soon as
the indicator stops flashing and remains lit.
Note:
Wait
until the scanner
has made a'complete
trip before feeding the second sheet of paper.
Two-Sided
Copying
1)
Make
sure that
the following
conditions
are met:
Turn over the copy paper, keeping its near
and far edges oriented
the same way for
both sides.
The copy paper is not moist or curled.
The
copy, paper
is 60
to
128
g/m2
in
weight.
Each side of the copy paper is used for a
single copy run only.
The
copy
paper
has not been
used
for
overlay copying.
Near edge
Near edge
Figure l-7
COPVAIGHT
018sD CANON
INC.
CANON
HP-1010 AN.0
DEC. KlBtl PAINlEO
IN JAPAN IIMPAIME
AU JAPONI
l-7
Advertisement
Table of Contents
