Canon NP-1010 Service Manual page 74

4)
Pull out the arm to the front (arrow A).
and pull out the paper detection lever in
the direction of arrow 6.
@ Paper detection lever @ Arm
Figure 4-60
5) Remove the black face seal and three
screws, and remove the front heater termi-
nal mount.
@ Thermoswitch mount
@ Screws
@ Screw (wi washer)
Figure 4-62
8) Remove the three screws, and remove the
paper guide.
@ Heater terminal mount
@ Screws
@ Screw (w/ washer)
@I Face seal
Figure 4-61
6) Pull out the heater slowly to the front.
7) Peel off the black face seal and remove
the three screws, and remove the ther-
moswitch mount.
@
Screws
@ Paper guide
Figure 4-63
9) Remove the spring from the fixing assem-
bly drive gear unit.
10)Remove the E-ring, and remove the fixing
assembly drive gear unit.
Note:
Take care; some side plates are fitted with an
E-ring on the back.
@ Spring
@ E-ring
@I Fixing assembly drive
gear unit
Figure 4-64
COPVGIGHT 019GG
CAGOG INC. CANON HP-1010 AN.0 DEC. 1988 PRIHTEG IN JWAH IIMPGIME AU JWONI
4-21